Celebrating the products of AEC Southall Ltd, most famous as builder of London's buses.

It is currently Sun Nov 28, 2021 6:27 am

All times are UTC

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Pipe union thread
PostPosted: Mon Jul 13, 2015 12:17 pm 

Joined: Sun May 18, 2014 10:35 pm
Posts: 17
I am wanting to replace the pipe from the clutch reservoir to the master cylinder on my Mandator mkv, I recently fitted a new master and slave cylinder to it and the feed pipe wasn't looking that good also the flats on the union had been damaged and I found it very difficult to tighten, I would like to know what size unions I need to replace them with so I can make up a new pipe.
Also I would like to re seal the foot break valve, I think it is a Bendix type single line (it has one feed in one out with an air switch in to it and another pipe out of the bottom)
does anyone know where I can get a seal kit from and what the union thread is for the master cylinder??????
Thanks Graham

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group