I am wanting to replace the pipe from the clutch reservoir to the master cylinder on my Mandator mkv, I recently fitted a new master and slave cylinder to it and the feed pipe wasn't looking that good also the flats on the union had been damaged and I found it very difficult to tighten, I would like to know what size unions I need to replace them with so I can make up a new pipe. Also I would like to re seal the foot break valve, I think it is a Bendix type single line (it has one feed in one out with an air switch in to it and another pipe out of the bottom) does anyone know where I can get a seal kit from and what the union thread is for the master cylinder?????? Thanks Graham
|